Differences

This shows you the differences between two versions of the page.

--- mse-em-board:lcd [2020/04/17 15:30] – external edit 127.0.0.1
+++ mse-em-board:lcd [2020/09/29 15:43] (current) – adm-hga3
@@ Line 3: / Line 3: @@
 The MSE-Embedded platform contains one LCD as indicated in the below figure.
-{{ :huce:microlab:projects:internal:mse-em-board:mse-em-board_wav_lcd.jpg?direct&400 |}}
+{{ :mse-em-board_wav_lcd.jpg?direct&400 |}}
-The MSE-Embedded board contains a RGB LCD 320*240 pixels. The datasheets can be found {{:huce:microlab:projects:internal:mse-em-board:lcd_240x320.pdf| here}}.
+The MSE-Embedded board contains a RGB LCD 320*240 pixels. The datasheets can be found {{:mse-em-board:lcd_240x320.pdf| here}}.
-The control pins of this LCD which are connected to the FPGA are listed in the table below. An example tcl-file that can be used with Quartus can be found {{:huce:microlab:projects:internal:mse-em-board:lcd.tcl| here}}.
+The control pins of this LCD which are connected to the FPGA are listed in the table below. An example tcl-file that can be used with Quartus can be found {{:mse-em-board:lcd.tcl| here}}.
@@ Line 84: / Line 84: @@
 </html>
-The initialization code that can be used with the Nios can be found {{:huce:microlab:projects:internal:mse-em-board:lcd_simple.c|here (lcd_simple.c)}} and {{:huce:microlab:projects:internal:mse-em-board:lcd_simple.h|here (lcd_simple.h)}}.
+The initialization code that can be used with the Nios can be found {{:mse-em-board:lcd_simple.c|here (lcd_simple.c)}} and {{:mse-em-board:lcd_simple.h|here (lcd_simple.h)}}.
 <note tip>When choosing 8bit mode (IM0 = 1) use DATA8 - DATA15 as data bus and set DATA0 - DATA7 to 0. In 16-bit mode (IM0 = 0) use DATA0 - DATA15.</note>